How to remove transmission cooler lines from transmission alero?

1
Dortha Kuhlman asked a question: How to remove transmission cooler lines from transmission alero?
Asked By: Dortha Kuhlman
Date created: Fri, Jul 23, 2021 7:51 AM
Date updated: Mon, Jan 24, 2022 8:54 AM

Content

Top best answers to the question «How to remove transmission cooler lines from transmission alero»

How do you remove cooler lines from transmission?

  • Use the flare nut wrench to remove the lines in the same manner used to remove the lines from the transmission. Slide both transmission cooler lines away from the vehicle, pulling each line from the transmission rather than the radiator to complete the removal process.

FAQ

Those who are looking for an answer to the question «How to remove transmission cooler lines from transmission alero?» often ask the following questions:

❓ How to remove transmission cooler lines from transmission?

How long to remove a transmission?

  • The time it takes to remove a transmission varies from vehicle to vehicle and depends greatly on the complexity of the vehicle's transmission and drive train. Most repair shops charge for between five and 15 hours of labor for work that involves removal and re-installation of a transmission.

❓ How do you remove cooler lines from transmission?

  • Use the flare nut wrench to remove the lines in the same manner used to remove the lines from the transmission. Slide both transmission cooler lines away from the vehicle, pulling each line from the transmission rather than the radiator to complete the removal process.

❓ How to remove transmission cooler lines from jeep?

  • Drain the coolant from the smaller radiator into the drain pan. Close the petcock once drained. Loosen the metal clamping nuts that secure the sending and return transmission cooler lines to the side of the radiator with an open-ended wrench. Pull the lines off of the radiator.

Your Answer

We've handpicked 22 related questions for you, similar to «How to remove transmission cooler lines from transmission alero?» so you can surely find the answer!

What causes transmission cooler lines leak?

Transmission cooling lines leaking means either low-level of fluid or interrupted flow in the transmission. In both cases, the result is an overheated transmission that may stop functioning if the condition persists. Sometimes, it is difficult to spot the leak at the initial stage.

How do you remove the transmission cooler lines from the transmission on a 1992 jeep cherokee loredo?

The bottom fitting is a quick connect fitting. You usually use a special tool to release this fitting. Some auto parts stores will lend you the necessary tool for free. The top line will be a flare fitting, which will require the proper sized end wrench or line wrench to remove.

Can you use hydraulic lines for transmission cooler lines?
  • keep in mind that transmission cooler lines normally run between 60-80psi, so there's really no need to run hydro lines. i think braided line is overkill. i'm a big fan of running the steel 5/16th hardline. they NEVER leak and they're damn cheap.
Which is better transmission cooler lines or nylon lines?
  • Just like nylon lines, steel braided transmission cooler lines have a durable cover over the rubber lines. These are far more durable than rubber and are also stronger than nylon. With that added strength comes added cost. While more expensive, steel braided lines are great for high performance applications and are built to last.
How do you remove cooler line from transmission?
  • Select proper wrench size, depending on the size of the cooler line fittings. Unscrew the fittings. Remove cooler line from transmission fitting. Pull the line out of the transmission fitting, taking care not to bend the line.
Can you drive without transmission cooler lines?

Why do you need a transmission cooler line?

  • A transmission cooler line helps maintain the temperature of a vehicle's transmission so it doesn't burn up. Disconnecting a transmission cooler line without a quick disconnect tool is a fairly simple task provided you have the proper tools.
Does a manual transmission have cooler lines?
  • Transmission: Manual. Question: Are there stock transmission cooler lines in a manual transmission on these cars? Doubt any you listed have manual transmission coolers. manuals don't have a torque converter and don't generate as much heat like an automatic, so not needed. Also, there's no pump to move the fluid. So in stock form, no.
How do transmission oil cooler lines work?
  • How does the transmission oil cooler line work? The transmission cooler lines carry transmission fluid back and forth between the transmission, and an external or radiator integrated cooler. They are often part or wholly metal, and screw in the transmission and transmission cooler at either end.
How do you transmission cooler lines at?

How do you remove transmission lines?

  • Remove the two transmission cooler lines from the bottom of the radiator . These two lines can be accessed either from underneath the hood or underneath the vehicle. Use the flare nut wrench to remove the lines in the same manner used to remove the lines from the transmission.
How long to replace transmission cooler lines?
  • How Long Does Cooling Line Replacement Take? Repairing the cooling line for your transmission can take quite a bit of time. You can expect to leave your vehicle at the repair shop for a day or two for this repair. Remember, transmissions are complex pieces of your engine, and the leak needs to be repaired thoroughly to protect your vehicle.
How much pressure on transmission cooler lines?
  • Click to see full answer. Also to know is, how much psi should be in a transmission cooler line? Cooler and lube pressure are about the same at 5-30 psi. The fluid goes from the converter to the cooler to the output shaft support. Additionally, what causes low line pressure in a transmission?
What are transmission cooler lines made of?

Also known as transmission cooling lines, they are typically made of metal or composite aluminium and rubber hoses because they can handle the flow of hot transmission fluid.

What causes transmission cooler lines to leak?
  • The most common transmission cooler failures are due to either a leak in the body of the cooler itself, or a clogged line caused by something flowing through the system. This most likely is from the transmission itself. If left unattended, the transmission will run low on atf which will increase the fluid temperature and cause premature failure.
What size are th400 transmission cooler lines?

Most 400s use 5/16" flare fittings, and 5/16" lines, most radiators do too.

When should transmission cooler lines be replaced?

Once it starts releasing a lot of liquid, exudes burnt smell and approaches complete malfunction, it will have already brought substantial damage to the transmission. Thus, once you notice minor issues with the cooler lines, it is best to replace them right away.

Who makes gm transmission oil cooler lines?

What does Dorman transmission oil cooler line do?

  • Dorman transmission cooler lines feature premium materials to provide better and longer-lasting protection for transmissions. Dorman lines for specified vehicles include thermostatic bypass valves, the newest technology that optimizes flow and operating temperature of transmission fluid.
How do you remove oil cooler fluid from transmission?
  • Slide the drain pan under the transmission pan. Loosen the bolts on the transmission pan and allow the pan to slowly tip. The fluid will drain into the drain pan. Properly discard the transmission fluid. Disconnect the oil cooler hoses from the transmission using the appropriate line wrench.
Are there benefits to replacing transmission cooler lines?
  • Benefits of Transmission Cooler Lines Replacement. You will benefit from replacing the damaged lines by saving on transmission fluid. You will also protect the parts of your car that could be damaged by leaking fluid or by low fluid levels.
Can i made my own transmission cooler lines?

What causes a transmission cooler to leak?

  • Heat causes oxidation. Oxidation causes a brown tarnish that coats the dipstick, transmission case and other components inside the transmission. This tarnish also causes transmission valves to stick, resulting in delayed and unusual shifting. If the fluid is pink and milky, the transmission cooler is leaking.
Do transmission cooler lines require a double flare?

What are the different types of transmission cooler lines?

  • Types of Transmission Cooler Lines 1 Metal Transmission Cooler Lines. Metal transmission cooler lines are typically pre-bent with fittings that are held on by a flare at each end of the line. 2 Rubber Transmission Lines… 3 Nylon Braided Transmission Cooler Lines… 4 Steel braided Transmission Cooler Lines…
How big are the transmission fluid cooler lines?
  • "Transmission fluid cooler lines: on the 700R4 the bottom fitting on the right side of the transmission is the "out" line to the cooler and the top fitting is for the return line from the cooler. These fittings are 1/4-inch pipe thread, and CAN include an adapter from the factory for threaded steel lines in an SAE size."
How do transmission cooler lines connect to radiator?

The hoses traveling from the transmission to the radiator are called transmission cooler lines. They channel hot transmission fluid to the radiator, where it is cooled, then return it back to the transmission. They typically resemble brake lines and are made of metal.